Training Board for Triac
Product Code : JA-AET-1461
The TRIAC training board is used to study the gate characteristics of a TRIAC in modes I+, I-, III+ and III-, its terminal characteristics in modes I+ and III+, and its holding current. It also demonstrates the TRIAC as a static switch under DC control and the control of AC with an AC signal, using built-in 0-70 V and 0-3 V DC regulated supplies and 55 V and 7 V AC supplies (SKU JA-AET-1461).
Specifications
Parts and ratings built into the TRIAC board:
| Product | Training Board for Triac |
| SKU | JA-AET-1461 |
| DC supplies | 0-70 V DC at 100 mA and 0-3 V DC at 30 mA, regulated |
| AC supplies | 55 V at 100 mA and 7 V at 30 mA, fixed |
| Device | TRIAC |
| Controls | Three potentiometers; reset switch |
| Mains | 230 V ±10%, 50 Hz AC; ON/OFF switch, fuse and jewel light |
| Patch cords | 4 mm spring-loaded plugs, stackable from the rear at both ends, 0.5 m |
| Other apparatus required | CRO 20 MHz; digital DC current meters (20 mA / 200 mA and 200 mA ranges); digital DC voltmeter (2 V / 200 V) |
TRIAC studies
The listed experiments are:
- Gate characteristics in modes I+, I-, III+ and III- (T2 and gate polarity with respect to T1)
- Terminal characteristics in modes I+ and III+
- TRIAC as a static switch (DC control)
- Control of AC with an AC signal
- Holding current (IH) measurement
Scope of supply and ordering
The listing covers the TRIAC training board with patch cords and operating instructions, supplied by JaincoLab; the meters and oscilloscope are listed as other apparatus required.
Frequently asked questions
Which TRIAC modes are covered?
Gate characteristics in modes I+, I-, III+ and III-, and terminal characteristics in modes I+ and III+.
What applications does the board demonstrate?
The TRIAC as a static switch under DC control and the control of AC with an AC signal.
Are meters built in?
No. Digital DC current meters, a digital DC voltmeter and a 20 MHz oscilloscope are listed as other apparatus required.
Related products
- Silicon Controlled Rectifier
- Training Board for DIAC
- Triac and AC Phase Control
- Lamp Dimmer Using Diac and Triac
The analog electronics trainer range lists further items of this kind.
Request a quote
Send your requirement for the Training Board for Triac to [email protected] or use the contact page. Tender and project enquiries can be sent through the tenders page.
