• +91-85699-09696

Solar Energy Trainer, Boiler Type

Solar Energy Trainer, Boiler Type

Product Code : JA-LABCS-9621

The Solar Energy Trainer, Boiler Type is a closed-loop solar thermal trainer for solar hot water heating, as used in homes and commercial buildings. A flat plate collector with a 0.5 m² aperture heats water that a pump circulates to an insulated 15 L hot-water store. A 500 W electric heater tops up the heat when the sun is weak. The store is a training reservoir, not a pressure boiler.

Specifications of the boiler-type solar energy trainer

Product codeJA-LABCS-9621
SystemClosed-loop solar thermal trainer for solar hot water heating
CollectorFlat plate solar collector, 0.5 m² aperture
Hot-water storeInsulated store, 15 L; a training reservoir, not a pressure boiler
Electric assist500 W electric heater in the store
CirculationCirculating pump in the collector loop
InstrumentsTemperature and flow sensors with a readout
ProtectionThermostatic control and over-temperature protection
Mains supply230 V AC, 50 Hz
Supplied withDiagram of the solar collection and control circuit; manual
ManufacturerJaincoLab, Ambala, India

Practical work on the boiler-type solar trainer

  • Heat collected in the store. Switch the heater off and run the pump in steady sunshine. Log the store temperature at fixed intervals, timed with a Digital Stop Watch. The temperature rise of the 15 L of water gives the solar heat collected.
  • Inlet, outlet and flow. Read the collector inlet and outlet temperatures and the flow on the readout. Work out the useful heat gain per minute and repeat the readings at another time of day.
  • Sensor check. Hold a Digital Stem Thermometer in the store beside the temperature sensor. Compare the two readings with cool water and again with warm water.
  • Electric assist power. With the collector covered, switch on the heater and measure its current with a Digital Clamp Meter. Multiply by the mains voltage and compare the result with the 500 W rating.

Frequently Asked Questions

How does the pump flow rate change the collector outlet temperature?
A fast flow carries heat away before the water warms much, so the outlet is only a little hotter than the inlet. A slow flow gives a hotter outlet, but the collector then runs hotter and loses more heat to the air. Students record both readings and compare the useful heat at each flow.

How do students work out the solar heat stored in the 15 L tank?
Multiply the mass of water by its specific heat and by the rise in store temperature. Fifteen litres of water weigh about fifteen kilograms. Take the start and end temperatures of a timed run with the electric heater off, so that only solar heat is counted.

Why does the trainer have over-temperature protection as well as a thermostat?
A thermostat can stick and keep the heater on. The separate over-temperature protection switches the heater off if the store gets too hot, whatever the thermostat is doing. The two together keep the training store below boiling and protect students from scalds.

What should be checked before the pump and the heater are switched on?
Fill the collector loop and the store, and let the air out so that the pump is primed. Start the pump and check that the flow reading moves. Only then switch on the 500 W heater, because a heater in an empty or air-locked store can overheat.

What is included in the scope of supply of the boiler-type solar trainer?
The supply covers the flat plate collector with a 0.5 m² aperture and the insulated 15 L store with its 500 W heater. It also includes the circulating pump, the temperature and flow sensors with their readout, the circuit diagram and the manual. Add any extra items to the enquiry.

Which mains supply does the 500 W electric heater need?
The trainer is built for 230 V AC, 50 Hz mains, and the heater, pump and readout all run from it. Thermostatic control and over-temperature protection are fitted. If your site uses a different mains voltage, give it in your enquiry before you order.

Other solar energy trainers in the range

For Ministry of Education, World Bank and United Nations laboratory projects, JaincoLab works as manufacturer and exporter and has completed such supplies successfully in many countries. Firms preparing bids for these tenders can request itemised quotations and turnkey supply of the full laboratory scope from our tenders team.

See the Renewable Energy Equipment range and more physics apparatus from JaincoLab, a physics lab equipment manufacturer in India.

For a quotation, send the product name and the quantity you need through our contact page. For tender or project supply, see our tenders page.

Last updated: 20 November 2026

   
Supply of Solar Energy Trainer, Boiler Type from to Finland, France, Tanzania, Thailand, Sri Lanka, Congo, Costa Rica, Ivory Coast, Croatia, Cuba, Cyprus, Czech Republic, Denmark, Djibouti, Dominica, Afghanistan, Albania, Algeria, Andorra, Angola, Antigua and Barbuda, Argentina, Armenia, Australia, Austria, Azerbaijan, Bahamas, Bahrain, Bangladesh, Barbados, United Arab Emirates (UAE, Dubai), United Kingdom (London), United States, Uruguay, Uzbekistan, Vanuatu, Belarus, Belgium, Belize, Benin, Bhutan, Bolivia, Bosnia and Herzegovina, Botswana, Brazil, Brunei, Bulgaria, Burkina Faso, Burma Myanmar, East Timor, Ecuador, Egypt, El Salvador, Equatorial Guinea, Eritrea, Estonia, Ethiopia (Addis Ababa), Fiji, Burundi, Cambodia, Cameroon, Canada, Cape Verde, Central African Republic, Chad, Chile, Colombia. Math Teaching Kit suppliers in Luxembourg, Macedonia, Madagascar, Malawi (Lilongwe), Malaysia (Kuala Lumpur), Maldives, Mali, Malta, Marshall Islands, Mauritania, Mexico, Micronesia, Moldova, Monaco, Mongolia, Montenegro, Morocco, Mozambique, Namibia, Comoros, Congo. Math Teaching Kit manufacturers in Dominican Republic, Gabon, Gambia, Georgia, Germany, Ghana, Greece, Grenada, Guatemala, Guinea, Guinea-Bissau, Guyana, Haiti, Honduras, Hungary, Iceland, Indonesia, Iran, Iraq, Niger, Nigeria (Abuja), Norway, Oman, Palau, Panama, Papua New Guinea, Paraguay, Peru, Philippines (Manila), Poland, Ireland, Israel, Italy, Jamaica, Japan, Jordan, Kazakhstan, Kenya (Nairobi), Kiribati, Korea, Kuwait, Kyrgyzstan, Laos, Latvia, Lebanon, Lesotho, Liberia, Liechtenstein, Lithuania, Mauritius, Nauru, Nepal, Netherlands, New Zealand, Nicaragua, Portugal, Qatar, Romania, Russia, Rwanda (Kigali). Math Teaching Kit exportets to Saint Kitts and Nevis, Saint Lucia, Saint Vincent and the Grenadines, Samoa, San Marino, Sao Tome and Principe, Saudi Arabia, Senegal, Serbia, Seychelles, Sierra Leone, Singapore, Slovakia, Slovenia, Solomon Islands, Somalia, South Africa, South Sudan, Spain, Sudan, Suriname, Swaziland, Sweden, Switzerland, Syria, Tajikistan, Togo, Tonga, Trinidad and Tobago, Tunisia, Turkey, Turkmenistan, Tuvalu, Uganda (Kampala), Ukraine, Venezuela, Vietnam, Yemen , Zambia (Lusaka), Zimbabwe

Office Address

Jain Scientific Suppliers
2475-84, Hargolal Road,
Ambala Cantt, Haryana, India

[email protected]

+91-85699-09696

Follow Us