Original Alternator
Product Code : JA-EF-9745
The Original Alternator is a 12 V vehicle alternator for classroom and workshop training. It serves for demonstrations and exhibits, as a replacement part on engines, or on an alternator and generator test bench. The standard new build has an internal regulator, a nominal 14 V charging output and a guarded drive. A remanufactured alternator is offered only as a separate option, with a written quotation and a test report.
Specifications of the 12 V alternator
| Product code | JA-EF-9745 |
|---|---|
| Vehicle system | 12 V nominal |
| Charging output | Nominal 14 V* |
| Rated current | About 90 A at the specified test speed and temperature, in the standard new build* |
| Regulator | Internal regulator* |
| Drive and mounting | Guarded drive for bench running*; wooden display base as an option |
| Condition | Supplied new as standard; a remanufactured unit is a separate option, quoted in writing with a test report |
| Uses | Demonstration, exhibits, replacement part and alternator/generator test bench work |
| Manufacturer | JaincoLab, Ambala, India |
* Standard JaincoLab specification for new builds.
Charging system practicals with the alternator
- Output against speed. Run the alternator on the Automotive Electrical Test Bench at several drive speeds, checked with a Tachometer. Record the output current and voltage at each speed.
- Regulated voltage. Raise the speed with a light load and watch the output voltage settle at its regulated value on a Digital Multimeter. Add load and see the regulator hold the voltage.
- Ripple and diodes. View the output on the 30 MHz Oscilloscope. A healthy rectifier shows a small, even ripple, while a failed diode leaves a repeating gap.
- Alternator and dynamo. Repeat the speed run with the Original Generator and compare the two outputs at low speed.
Frequently Asked Questions
Why is a good alternator sometimes blamed for a charging fault?
Many charging faults lie in the wiring rather than the alternator itself. A loose or corroded terminal, a poor earth strap, a blown fuse link or a weak battery can all look like a failed alternator. Check these first, then test the alternator output on a bench before replacing it.
How do the rectifier diodes turn the stator output into direct current?
The stator produces three-phase alternating current. The rectifier, a bridge of diodes, lets current pass one way only, so each phase charges the battery on both halves of its cycle. Together the three phases give a DC output with only a small ripple.
What precautions apply when students work on an alternator?
Disconnect the battery before removing or fitting the alternator. Never run it with the output lead disconnected, as the voltage can rise and damage the diodes. Never reverse the battery connections. Keep hands clear of the pulley and belt while it is driven on the bench.
What output is the standard alternator rated for?
The standard new build is for a 12 V vehicle system. It has a nominal 14 V charging output and about 90 A at the specified test speed and temperature. The rating belongs to this build, not to every alternator that fits the same engine. Name the vehicle or bench you plan to use in the enquiry.
How is a remanufactured alternator documented if we choose one?
A remanufactured alternator is a separate option from the standard new unit. It is quoted in writing and comes with its own test report, so the buyer has its output on record at handover. Ask for it in the enquiry if you need it.
Other automotive electrical components in the range
See the Automotive Electrical Trainers and Components range and more electronics lab equipment from JaincoLab, an electronics lab equipment manufacturer in India.
For a quotation, send the product name and the quantity you need through our contact page. For tender or project supply, see our tenders page.
