Mortar and Pestle
Product Code : JA-MAP-1392
This porcelain mortar and pestle is used to grind and mix solids in the lab. Six sizes are listed, from 60 mm to 175 mm outside diameter. Capacities run from about 70 ml in the 75 mm size to about 860 ml in the 175 mm size. The 60 mm set is partially glazed.
Sizes of the porcelain mortar and pestle
| Product code | JA-MAP-1392 |
|---|---|
| Material | Porcelain |
| 60 mm size | Partially glazed mortar and pestle |
| 75 mm size | 75 mm outside diameter, about 70 ml |
| 100 mm size | 100 mm outside diameter, about 160 ml |
| 125 mm size | 125 mm outside diameter, about 370 ml |
| 150 mm size | 150 mm outside diameter, about 620 ml |
| 175 mm size | 175 mm outside diameter, about 860 ml |
| Measurements | Approximate |
| Manufacturer | JaincoLab, Ambala, India |
Grinding and mixing with the mortar and pestle
- Preparing a salt for a solution. Grind the crystals to a fine powder so they dissolve quickly, then weigh the powder on a digital balance.
- Powdering plant material. Grind dried leaves or roots in one of the larger mortars, then pass the powder through a test sieve for an even particle size.
- Small-scale tests. Grind a pinch of the sample, scrape it out with a spatula and test small portions on a cavity reaction spot plate.
Frequently Asked Questions
Which size of mortar should I choose?
Choose a mortar well larger than the amount you need to grind. Fill it to about a third at most, so the pestle moves freely and nothing spills. The 60 and 75 mm sizes suit small samples, while the 150 and 175 mm sizes take larger batches.
What is the difference between a glazed and an unglazed grinding surface?
A rough, unglazed surface grips the particles and grinds faster, but it can hold stains and traces of earlier samples. A smooth glazed surface is easier to clean and suits mixing. The 60 mm set in this range is partially glazed.
How do I grind a solid to a fine powder?
Add a little of the solid at a time. Press down with the pestle and work it in circles from the centre outwards. Scrape the powder down from the sides with a spatula now and then, and stop when no grains can be felt.
Is a porcelain mortar right for every sample?
It suits most salts, crystals and dried plant material. Very hard materials wear the surface and can leave porcelain dust in the sample. An agate mortar is the better choice for those and for samples sent for trace analysis.
How should the mortar be cleaned between samples?
Wash it with water and a brush straight after use. For stubborn residue, grind a little clean sand or salt in it, then rinse well. Dry it fully before the next sample, so nothing carries over.
What is the difference between trituration and levigation?
Trituration is grinding a dry solid to a fine powder with the pestle. Levigation is grinding a solid with a little liquid to a smooth paste. Pharmacy students use levigation before working a powder into an ointment.
Other mortars and pestles in the range
See the Mortar and Pestle Ware range and more porcelain ware from JaincoLab, a laboratory porcelain ware manufacturer in India.
For a quotation, send the product name and the quantity you need through our contact page. For tender or project supply, see our tenders page.
