Bearings and Seals Manufacturer,Supplier and Exporter in India

Bearings and Seals

Product Code : JL-MAM-10319

The Bearings and Seals jaincolab consists of hardware and tools to teach bearings and seals. Some of the required tools are included in the Level 3 Accessories model. Three assemblies, each representing a typical application with various bearings and seals, are available for students to experiment with proper installation and maintenance procedures. The applications are designed to allow multiple assembly/disassembly cycles so that a variety of bearings and seals installation and removal procedures can be learned. One application represents a pump, another a hub, and a third a gearbox.

The following components are included:
1x assembly representing a gearbox consisting of two housings, three covers, a part representing a gear, one shaft, one spherical roller bearing, one cylindrical roller bearing, one adapter sleeve, one nitrile rubber O-ring, one radial shaft seal with a rubber double lip, a spacer, a shim, and all the fasteners required to complete the assembly, including retaining rings and a shaft key.
1x assembly representing a pump consisting of three stainless steel housings, one cover, one shaft, one part representing the impeller, a mechanical seal, two angular contact ball bearings, a deep-groove ball bearing, one nitrile rubber O-ring, one radial shaft seal with a rubber lip and a steel case, one V-ring seal, and all the fasteners required to complete the assembly, including shaft locknut, lock washer, retaining rings, and a shaft key.
Two panels for storage and inventory, with printed part names and outlines for identification purposes. Each panel has two handles and is designed to be stored on a wall-mounted support or inside the optional work bench.
1x assembly representing a hub consisting of two covers, one housing, one bracket for installation on the extrusions of the workstation, one tapered roller bearings, one radial shaft seal with a rubber double lip and a steel case, one paper gasket, and all the fasteners required to complete the assembly, shaft locknut, lock washer, retaining rings, and a shaft key.
Two panels for storage, inventory, and identification of the pump, hub, and gearbox assemblies. An outline of each assembly is printed on the panel. The panel has two handles and is designed to be stored on a wall-mounted support or inside the optional work bench.
1x roll of water-resistant gasket material.
Six mandrels and one holder, used while inserting/removing the bearings and seals.
2x support plates, to be used with the arbor press while inserting/removing bearings and seals.
One bearing support to be used with the bearing heater.
1x printed copy of the instructor manual. The content of this instructor manual is the same as the student manual (sold separately), but also includes answers and comments. The topics covered in this manual are:
- Removal/installation of gaskets, lip seals, mechanical seals, O-rings, and axial seals
- Proper use of an arbor press and a hammer for installation/removal of bearings
- Use of a splitter/puller when removing bearings
- Introduction to cleaning and lubrication of bearings
- Installation of a bearing by heating the inner raceway
- Removal/installation of shaft locknuts, lock washers, and snap rings

    Download as Pdf  

Office Address

Jain Scientific Suppliers
2475-84, Hargolal Road,
Ambala Cantt, Haryana, India

[email protected]

+91-85699-09696

Follow Us